For Pinless Wands
(Does not require a PA piercing)

For the pinless wands, we need measurements; D1, D2, D4, D6, and the Glans Ring size.

D2 Ring Setback for Pinless Wands only: Pinless wands don’t have a P/A post, but we still need the measurement so that the Glans Ring will be located behind the Glans (head). Most cases it will be from 3/8” to 3/4”.

For Pinned Wands

D1 Wand Length: 1” to 9”. We have found that a 3-1/2” is a good starter size for most. If the wand is over 4” there is an additional charge.

D2 Pin Setback: This is the distance from your P/A piercing to the end of your urethra. In most cases it will be from 3/8” to 3/4”, but each one is different.

D3 Pin Length: For this you will have to put something in the urethra such as our sampler kit, and then take a small dowel, or a toothpick and put through the P/A piercing until it touches the item inserted in your urethra, then measure that distance. Most that we make are 1/8” to 3/8”, but there is no standard, each wand is different!

D4 Front ball: Depending on the wand size, I would recommend 7/16, 1/2, or 5/8. Ball sizes over 5/8 carry an additional fee, however we do have balls in stock up to 1-1/2”.

D5 Pinball: Most that I do are 3/8”.

D6 Wand diameter: This is a tough one. If you are not a sounder, you may not have an idea of what size you want for your urethra.
We do carry a Stainless Steel sampler set for sizing that includes a 1/4”, 5/16”, and a 3/8”. Each has a rounded end for ease of insertion, and in this way you can get the correct sizes from the start. They also work well for help with measuring the D3 dimension. These are $32.00 per set and you can find them here Sizer Set . If the wand is over 3/8” in diameter, there is also an extra charge. This is one of the most important sizes required for a good fit of your wand!

D7 The pin size: This will be the pa size you have. We can make these from 10 gauge to 000 gauge.

Taper: If you would like your wand tapered, there is a $40.00 charge for that. In most instances, we recommend only a starter taper though on the larger wands, and the cost for that is only $20.00. If the D6 wand diameter size is less than 5/16”, then we can not taper the wand.

Slave rings: Are available for both the D4 and/or the D5 balls and are an additional $25.00 each.

Glans ring: If you are unsure of the size, we also carry a sampler set of O rings for sizing, which consists of nine O rings ranging in size from 3/4 to 1-7/16. The cost for the set is $12.00 and you can find that here Glans Sizer Set . You want the fit to be Not Tight, and also Not Loose, just snug While you are Hard.